win7 64bit, I always compile it to x64 and it works just perfect with the orginal script, but not after the changes.
(02-05-2015, 11:39 PM)jondra Wrote: [ -> ]win7 64bit, I always compile it to x64 and it works just perfect with the orginal script, but not after the changes.
If you got "Error cannot check for Dead Base, Attacking"
It because you was Run/Compile Script as x64 (it make dead base error).
TRY TO RUN IT AS X86, If you have the same issue. Try to re-install your AutoIt3
source: https://the.bytecode.club/showthread.php?tid=441
works fine with x86, thanks a lot
5.4.5.2.2 is really bad 2 line of barbs below then 2 line of barbs above then arch below etc etc.. so slowly by the time the archers went in no more barbs survived then next all archers died before scd wave lol