[promac]

and you need to choose / attack tab / deploy settings : use custom

[SongHyeKyo]

and you need to choose / attack tab / deploy settings : use custom

Thank You Very Much ..

This bot is good in attacking inside storage

[promac]

welcome ...
I made another change , i had issues with my almost max TH10 and detection of full army , it´s because the button position info camp.... if you have a TH10 please send me a PM ...
With Th9 or level below it´s OK ...
Closed This OffTopic ...

[buttonm]

Hello, thank you for this MOD.

I have a problem running it. Once i start the bot, the troops created isn't correct. It seems to make 1WB only.

Troops tab, i use custom troop setting.
8 G
6 WB
50% arch
50% barch

Attack tab i use deploy on all sides, and use custom

I used Promac algo of
giant:3:300:4:2
barb:3:100:30:3
wb:3:50:2:1
arch:3:500:40:5
giant:1:300:4:3
barb:1:100:30:2
wb:1:50:2:1
arch:1:500:40:4

Thanks!

[promac]

Hello, thank you for this MOD.

I have a problem running it. Once i start the bot, the troops created isn't correct. It seems to make 1WB only.

Troops tab, i use custom troop setting.
8 G
6 WB
50% arch
50% barch

1 - Close The Bot and delete config.ini and start again the Bot.
2 - After the initial configuration you need select / attack tab / deploy settings : use custom ( to use the  attack_algo.txt )
3- See if you put 50% Barb 50% arch 0% goblins , 8G and 6wb. ( put the zero value - Goblin , i had an issue with this )
3 - Start the bot without any troops in camps and barracks.

You must see what quantity of arch and barbs you are making and sets the value in the file attack_algo.txt  if the Sum between two deploys are less than what you are making the bot deploy always in edge BottomRight the remaining troops.

[buttonm]

Thanks promac.

Can you also send me the mix bot that you did with this troop deployment.

Thanks!

[ikogsakanding]

What about for Barch only?

[buttonm]

Followed your suggestions, but i can't get it to work.

I'll fiddle some more and see.

Thanks!

1 - Close The Bot and delete config.ini and start again the Bot.
2 - After the initial configuration you need select / attack tab / deploy settings : use custom ( to use the  attack_algo.txt )
3- See if you put 50% Barb 50% arch 0% goblins , 8G and 6wb. ( put the zero value - Goblin , i had an issue with this )
3 - Start the bot without any troops in camps and barracks.

You must see what quantity of arch and barbs you are making and sets the value in the file attack_algo.txt  if the Sum between two deploys are less than what you are making the bot deploy always in edge BottomRight the remaining troops.

[bkceem]

Here is my attack_algo

giant:3:300:4:2
barb:3:100:40:8
wb:3:100:4:1
arch:3:100:50:8
giant:0:100:4:2
barb:0:100:40:8
wb:0:100:4:1
arch:0:100:50:8

Everything is working good except it won't deploy wb and it said "Unknown unit". I already set custom troop in Attack tab. Is there anything wrong in my Attack_algo??? Thanks

[kaioz]

are you using the merged mod version? wb is not working there.

but wb is working on this original version huanyu gave